Renew-Duster

Sku Number Name Size Units
Per Case
Price
Per Case
Case
Qty
 
1580-10S Renew-Duster - 20 case min. 10 oz (284g) 12 $243.24
Packaging Order minimum case quantity only. Extra shipping fees may apply.
Order from an authorized distributor

Renew-Duster is formulated with new HFO-1234ze propellant, with a fraction of the global warming potential (GWP) of HFC-134a and HFC-152a based dusters. Renew-Duster is a drop-in replacement -- nonflammable, odorless, has low toxicity, and similar temperature.

Because HFO-1234ze is lighter than HFC-134a, there is more volume and blasts per can.

Features & Benefits

  • 100% pure HFO-1234ze
  • GWP less than 1/100th of HFC-134a
  • Nonflammable Air Duster
  • Moisture free
  • Zero residue
  • Safe on plastics
  • VOC exempt
  • Velocity 12 m/s

 

FAQ's

How can I stop a can of “canned air” aerosol duster from freezing up?

This phenomenon occurs due to the expansion of the compressed refrigerant liquid as it dispenses through the aerosol valve and flashes to a gas. If the aerosol is operated for a long period, frost may form on the can because it is freezing the surrounding water vapor from the air. If it is collecting on the material to be cleaned, the operator is dispensing for too long of a period or is dispensing it too close to the material. The frost will evaporate and leave no residue. However, particulate matter blown onto a sensitive surface may cause damage due to the high pressure of the duster if dispensed too closely to that surface.

How do I properly dispose of an aerosol can after it is empty?

It may be different state-by-state, so contact your state environmental agency for regional specific regulations. For a general guideline, here is the process according to EPA hazardous waste regulations 40CFR. The can has to be brought to or approach atmospheric pressure to render the can empty. Puncturing is not required, only that it “approach atmospheric pressure”, i.e. empty the can contents until it’s no longer pressurized. This insures that as much contents as is reasonably possible are out of the can. It is then considered “RCRA-empty”. At that point it can be handled as any other waste metal container, generally as scrap metal under the recycling rules. Note that the can is still considered a solid waste at this point (not necessarily hazardous waste).

Is there something I can do with the extension tube (straw) so it doesn’t get lost?

The aerosol trigger sprayers that are common on dusters, freeze sprays, and flux removers, have two ways to store the straw when not in use. The hole at the back of the body of the sprayer is just the right size for the straw to slide into place for storage. The slot below the trigger is also the right size for the straw to snap into place, which also has the advantage of locking the trigger.

How do I figure out the shelf life of a product?

The shelf life of a product can be found on either the technical data sheet (TDS), available on the product page, or by looking on the certificate on conformance (COC). The COC can be downloaded by going to https://www.techspray.com/coc. Once you have the shelf life, you will need to add it to the manufacture date for a use-by date. The manufacture date can be identified by the batch number. The batch code used on most of our products are manufacture dates in the Julian Date format. The format is YYDDD, where YY = year, DDD = day. For example, 19200 translates to the 200th day of 2019, or July 19, 2019. This webpage explains and provides charts to help interpret our batch numbers: https://www.techspray.com/batch-codes.

How do you use air duster (canned air)?

The can of duster must be held in an upright position when spraying. Do not tilt can more than 40 degrees during spraying operation or shake during use. Before use, press actuator to clear valve of any liquid product. Extension tube can be used to remove dust in tight areas. Use short bursts to prevent cooling of can.

What is the shelf life of air duster (canned air)?

If the can and valving is intact and undamaged, it will not leak or spoil, so can sit on a shelf for as long as 10 years.

Articles

Cleaners Developed to Minimize Global Warming Effect
With global warming in the news and greenhouse gases getting more regulatory attention, electronic and industrial manufacturers are on the look-out for ways to reduce carbon emissions. Techspray has been developing products for over a decade that have much lower Global Warming Potential (GWP), witho...
Read This Post

Everything You Need to Know About Air Duster …But Were Afraid to Ask
A short, definitive article on aerosol duster, or "canned air". Learn about the advantages and disadvantages of the different types of duster, potential environmental issues, and best practices for your operation.
Read This Post
You did not finish submitting your information to request a sample